SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
34 Verifying that the Daemon is Running
Verifying that the Daemon is Running
To verify that the SAN Manager LM daemon is running, type ps -e | grep TR and press
Enter.
If the daemon is running, this command should return the following response:
TRSANManServic.
For example:
If the daemon is not running, check the logfile (/tmp/Service.log) for errors. To start the
daemon, type ioscan and press Enter. If you want to verify that the daemon started
successfully, check the logfile.
Note For more information about the logfile, see page 35.
sb-c3po# ps -e |grep TR
14443 pts/0 0:00 TRSANManServic