SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
Assigning Fibre Channel Disks to HP-UX Hosts 29
Storage Management
Listing Newly Assigned Devices
To list the newly assigned Fibre Channel devices, type ioscan -k and press Enter.
Note When you use the ioscan -k command, newly assigned devices are listed, but
the HP-UX system does not scan for devices that have been added to the SAN
since the last ioscan.
When there are assigned devices, running ioscan will list the hardware paths to all of the
SAN Manager LM targets plus the assigned LUNs. For example:
10/1/4/0 fc HP Tachyon TL/TS Fibre Channel Mass Storage Adapter
10/1/4/0.8 fcp FCP Protocol Adapter
10/1/4/0.8.0.255.0 ext_bus FCP Device Interface
10/1/4/0.8.0.255.0.0 target
10/1/4/0.8.0.255.0.2 target
10/1/4/0.8.0.255.0.3 target
10/1/4/0.8.0.255.0.3.0 disk SEAGATE ST118202 CLAR18
10/1/4/0.8.0.255.0.4 target
10/1/4/0.8.0.255.0.4.0 disk SEAGATE ST118202 CLAR18
10/1/4/0.8.0.255.0.5 target
10/1/4/0.8.0.255.0.6 target
10/1/4/0.8.0.255.0.7 target
10/1/4/0.8.0.255.0.8 target
10/1/4/0.8.0.255.0.9 target