SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
28 Assigning Fibre Channel Disks to HP-UX Hosts
Assigning Fibre Channel Disks to HP-UX Hosts
When you run ioscan on an HP-UX host that has no assigned devices, all of the devices in
the SAN Manager LM database are listed with the hardware path to each target. For
example:
Since no devices are assigned to this host, no LUNs are listed.
Assigning Devices to an HP-UX Host
On a Windows NT SAN Manager LM host, run the administration application and assign
devices to an HP-UX host.
Note See the SAN Manager LM Administrator’s Guide for instructions on assigning
devices.
10/1/4/0 fc HP Tachyon TL/TS Fibre Channel Mass Storage Adapter
10/1/4/0.8 fcp FCP Protocol Adapter
10/1/4/0.8.0.255.0 ext_bus FCP Device Interface
10/1/4/0.8.0.255.0.0 target
10/1/4/0.8.0.255.0.2 target
10/1/4/0.8.0.255.0.3 target
10/1/4/0.8.0.255.0.4 target
10/1/4/0.8.0.255.0.5 target
10/1/4/0.8.0.255.0.6 target
10/1/4/0.8.0.255.0.7 target
10/1/4/0.8.0.255.0.8 target
10/1/4/0.8.0.255.0.9 target