SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
Supported Partition Map Formats 27
Storage Management
UPM Format
SAN Manager LM’s Universal Partition Map (UPM) format is not supported on HP-UX
hosts. If you try to assign any type of UPM partition to an HP-UX host, the following dialog
box appears:
If you click Yes to All or Yes, the following dialog box appears:
Click OK. If you want to assign this device to an HP-UX host, you must remove the UPM
from the device. For instructions, see the section “Erasing a UPM” in Chapter 5 of the
Administrator’s Guide.
Note You cannot erase the UPM on a device that contains an active database mirror
set partition. To erase the UPM on a database device, first remove the device
from the database.