SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
20 Starting SAN Manager LM
Starting SAN Manager LM
The SAN Manager LM daemon starts at boot time. To avoid a reboot after installing SAN
Manager LM on an HP-UX host, run ioscan to start the daemon.
Since the standard ioscan utility was modified when you installed SAN Manager LM (see
Table 3), running ioscan has additional functionality. When you run ioscan, if the SAN
Manager LM daemon is not running, ioscan will start it. When you run ioscan, the network
is scanned for new hardware and SAN Manager LM blocks the host from accessing Fibre
Channel devices that are not assigned to it in the SAN Manager LM administration
application.
Running ioscan
Type ioscan and press Enter.