SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
18
Installing SAN Manager LM
Note
In the Marked column, the SANManLM-CORE package will be listed as “Partial”
instead of “Yes” because the bundle includes components that are not enabled
for this release.
During the install analysis step, the installer checks for an existing SAN
Manager LM installation and verifies that installation prerequisites such as
available disk space are met.
The Install Analysis dialog box appears.
8. If the Status says
Ready
, click
OK
.
Note
If the install analysis does not return a
Ready
status, read the
Logfile
to
determine the cause of the failure.
The install confirmation dialog box appears.