SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
14
Pre-Installation
6. Is SAN Manager LM licensed for HP-UX hosts? Run SAN Manager LM on a Windows NT
host to check your licensing information. For more information about licensing, see the
SAN Manager LM Administrator’s Guide
.
7. Is the Fibre Channel network hardware (hubs, switch, etc.) powered up?
8. Are the optical/copper Fibre Channel cables properly connected to the HBAs, hubs or
switches, and storage disk array enclosures?
Have the following available:
•
The SAN Manager LM installation CD-ROM
•
SAN Manager LM for HP-UX Release Notes
•
Fibre Channel hardware manuals
•
The
HP SureStore SAN Manager LUN Management Administrator’s Guide