SAN Manager LM for HP-UX Release Notes
Table Of Contents
- 1 Installation
- 2 Storage Management
- 3 Troubleshooting
- Verifying that the Daemon is Running
- Viewing the LogFile
- An HP-UX Host is Grayed Out in the Administration Application
- No SAN Devices are Available on an HP-UX Host
- An Assigned Device Is Not Accessible to an HP-UX Host
- Error During Mounting: “Not A Block Device”
- An HP-UX Host is not Discovered by a SAN Manager LM Administration Host
- A Device Cannot be Unassigned from an HP-UX Host
- Index
Pre-Installation
13
Installation
Pre-Installation
Install a Fibre Channel HBA Card Into Each Computer
1. Verify that the computer functions properly before installing the HBA.
2. Shut down the computer.
3. Install the HBA. For instructions, see the documentation that came with the A5158A
HBA.
4. Cable each computer to the hub or switch.
5. Power up the computer.
Pre-Installation Checklist
1. Does the computer meet SAN Manager LM’s system requirements?
2. Is the HBA installed?
3. Is the computer attached to a SAN?
4. Is the LAN up, running, and configured so it supports the LAN IP addressing scheme?
– Will the IP address on the HP-UX host work with the IP addressing scheme on the
Windows NT host(s)?
– Is the
Hosts
file on the Windows NT administration host updated with the HP-UX
host’s IP address? This is only necessary if DNS Services is not configured.
– Is the
/etc/hosts
file on the HP-UX host updated with the correct IP address that will
support the LAN IP addressing setup?
5. Is SAN Manager LM installed and configured on at least one Windows NT host
(preferably a Windows NT primary domain controller machine) on the SAN?