HP SureStore E SAN Manager LUN Management Administrator's Guide

106 Adding and Removing SAN Hosts
Adding and Removing SAN Hosts
SAN Manager LM hosts can be added to or removed from the SAN database without
rebooting network hosts or storage.
Adding a Host
1. Install a Fibre Channel HBA into the computer (page 21).
Caution If you are using a SAN Manager LM-ready HBA, do not install the HBA driver
until after SAN Manager LM is installed.
2. Cable the host to the hub or switch.
3. If necessary, install and register a new license key to enable the added host (see page
114 for instructions).
Caution Before installing SAN Manager LM, verify that there are no active Fibre
Channel HBA drivers installed on the host that is being added. If active Fibre
Channel HBA drivers are installed on the host, remove them before
continuing with step 4.
4. For Windows NT hosts, follow the software installation procedure on page 24. For
non-Windows NT hosts, follow the installation instructions in the appropriate SAN
Manager LM Installation Guide.