DLT VS80 Tape Drive Reference Guide

External Tape Drive Installation

21DLT VS80 Tape Drive Reference Guide

To set the SCSI ID use a small screwdriver or ballpoint pen to press the button

above or below the SCSI ID display.

■ Press the button above the SCSI ID display 1 to select the next lower SCSI

ID.

■ Press the button below the SCSI ID display 2 to select the next higher SCSI

ID.

Each time you press one of these buttons, the SCSI ID decreases or increases by

one. Press the appropriate button until the desired SCSI ID appears on the switch

display.

Note: SCSI ID 7 is reserved for the controller. The SCSI ID can be set up to 15, but a

SCSI ID above 6 is not recommended.

Figure 3: SCSI ID switch

Note: If the drive is powered on when you change the SCSI ID, you must power the

drive off and on again for the new SCSI ID to take effect.