HP SureStore E Disk Array FC60 Service Manual (A5635A)

Internal Controller Enclosure Assemblies 351
Removal and Replacement
If disconnecting the cable is difficult, the power supply cage/ midplane assembly may
need to be loosened and moved forward (Figure 123). To loosen power supply cage:
a. Remove the eight screws, four each side, from the power supply cage/ midplane
assembly (see Figure 123).
b. Pull the cage back a couple of inches to gain access to the power harness connectors
and disconnect the connectors from the back of the power supply/midplane cage.
4. Install the new harnesses.
5. Reinstall the power supply cage/ midplane assembly, if removed, by installing the eight
screws
6. Slip the harness cover plate over the four screws in the controller rear shield and press
it down then tighten the screws.
7. Install the controller enclosure into the rack. See "Controller Enclosure" on page 342.
For more complete installation instructions, see Chapter 3, Installation.