HP SureStore E Disk Array FC60 Service Manual (A5635A)

166 Applying Power to the Disk Array
Figure 67
Controller Enclosure Power Switches
5. Check the controller enclosure LEDs (see Figure 69). The Power LED should be on and
the remaining LEDs should be off. If any fault LED is on, an error has been detected.
Refer to "Troubleshooting" on page 207, for additional information.
6. Close and lock the disk enclosure doors.
7. If the host was shutdown to install the array, boot the host.
8. Perform an ioscan to verify that the host sees the array.
Power Switches