HP SureStore E Disk Array 12H User's and Service Manual (C5445-90901, September 1999)

Operating the Control Panel

Using Control Panel Menus

Control Panel

Language

The Language menu enables you to set the control panel language to one of five languages. After the

language is set, the control panel will display all messages in the selected language.

Deutsch Sets the control panel language to German.

English Sets the control panel language to English.

Espanol Sets the control panel language to Spanish.

Francais Sets the control panel language to French.

Italiano Sets the control panel language to Italian.

Cntrl Changes

The Cntrl Changes menu enables you to change SCSI controller parameters for the array.

SCSI ID

NOTE! If two controllers are installed and are connected to the same SCSI bus, they must each

have unique SCSI IDs.

Changes the SCSI ID (SCSI address) of controller x or controller y to any address from 0 to 15 (or offline)

and resets the controller.

Switch Cntrl

For arrays with two controllers, Switch Cntrl manually makes the secondary array controller become

“primary.” If the primary array controller fails during operation of the array, the array automatically

enables the secondary array controller to become “primary.”

Reset Cntrl

NOTE! During a controller reset, all disk module lights turn amber for three to fifty seconds, and

then go off.

Reset Cntrl resets controller x or controller y and runs internal diagnostics on the controller.