HP SureStore E Disk Array FC60 Service Manual (A5635A)

Internal Controller Enclosure Assemblies 353

Removal and

Replacement

3. Remove the power supply cage/ midplane assembly. See Figure 123.

a. Remove the eight screws, four each side, from the controller chassis.

b. Pull the cage back a couple of inches to gain access to the power harness connectors

and disconnect the connectors from the back of the power supply cage.

c. Remove the cage from the controller chassis.

4. Unpack the new power supply cage/ midplane assembly.

Figure 123

Power Supply Cage/ Midplane Assembly Removal

5. Slide the new power supply cage/ midplane assembly partially into the chassis and

reconnect the three DC power supply cables (Figure 123).

Controller Rear Shield