HP SureStore E Disk Array FC60 Service Manual (A5635A)

334 Controller Enclosure Modules
Figure 112
Controller Module Removal and Replacement
Installing the DIMM Card on the New Controller
Note
If you are upgrading a single controller disk array by installing an add-on
A5278A Controller Module, you do not need to perform the following
procedure. Skip to "Installing the Controller Module" on page 336
1. Using proper antistatic handling precautions, remove the replacement controller
module from the packing material.
2. Place the new controller on an antistatic mat.
3. Attach the grounding wrist strap to your wrist and ground the other end to the controller
enclosure.
Ensure handles are not extended
more than 90 degrees when
installing the module.