HP SureStore E Disk Array FC60 Service Manual (A5635A)

Disk Enclosure Modules 295
Removal and Replacement
5. Close the cam latch to seat the module firmly into the backplane. An audible click
indicates the latch is closed properly.
6. Check the LEDs (D in Figure 92) above the disk module for the following behavior:
– Both LEDs should turn on briefly.
– The amber Fault LED should turn off.
– The green disk Activity LED should blink for a few seconds and then go out. If the
host begins to access the disk, the Activity LED will flash.
If this behavior does not occur, refer to chapter 6, Troubleshooting, for information on
identifying and solving the problem.
7. Unplug the ESD strap, and close and lock the disk enclosure door.
Figure 92
Disk Module Replacement
A handle
Bcam latch
C capacity label
DLEDs