HP SureStore E Disk Array FC60 Service Manual (A5635A)

122 Installing the Disk Array FC60
Installing the Disk Array FC60
Installation of the Disk Array FC60 consists of installing the controller enclosure and up to
six disk enclosures. Before performing this installation you should have determined the
configuration for the array (as described in chapter 2, Array Planning and Topology). You
should also review this section prior to performing the installation.
The Disk Array FC60 is supported in the System/E racks and in the HP legacy (original)
cabinets. The Disk Array FC60 is also supported in Rittal 9000 racks.
Note
The HP SureStore E Disk Array FC60 has been tested for proper operation in
supported Hewlett-Packard cabinets. If the disk array is installed in an untested
rack configuration, care must be taken to ensure that all necessary
environmental requirements are met. This includes power, airflow,
temperature, and humidity. Failure to meet the required operating
specifications may result in product failure.