Optical Drive and Library SCSI-2 Command Reference
Autochanger Error Codes
Jukebox Micro-Move Error Codes
Appendix BB-48
23
Shipping Moves the picker to the appropriate position in
preparation for shipping.
24
Fill Picker Moves a cartridge into the picker from the first
full storage slot.
25
Empty Picker Moves a cartridge from the picker to the first
empty storage slot.
26
Zero Runtime Log The entire runtime log is initialized to all zeros.
27
Set Minimum Retries This sets the number of retries to 1. This may be
set to see if the chosen test is doing what you
want it to do. After you are satisfied that the test
is what you want, run Test 28 which resets the
number of retries to default values.
28
Set to Default Number
of Retries
Resets the number of retries to powerup default
values. Used after setting retries to 1 by Test 27.
29
Zero Error Log Sets Information Log 0, Autochanger Error Log
back to zero.
Electronic Core Tests
30 Microprocessor
Operation Test
Performs a functional check of the
microprocessor. This test will shut down the
servo system; a poweron sequence runs upon
completion.
31
ROM Checksum Test Performs a checksum verification of the ROM.
32
RAM Checksum Test A checksum of the "Controlled" area of RAM is
kept on an ongoing basis. This test verifies that
the checksum is still valid.
33
Non-Destructive RAM
Test
Tests all of the controller's RAM, checking for
data acceptance and retention. The test is non-
destructive to RAM unless interrupted by power
failure. This test will shut down the servo
system; a poweron sequence runs upon
completion.
Table B-13 Sequence Tests (For models 40fx, 80ex, 125ex, and 220mx ONLY)
No. Test Name Description