Optical Drive and Library SCSI-2 Command Reference

Autochanger Error Codes
Jukebox Micro-Move Error Codes
Appendix BB-36
6E Test failed
Table B-11 Micro-Move Error Codes (For the 40fx, 80ex, 125ex, and 220mx
models ONLY)
Error Code
(hex.)
Description
0 No error
1 Carriage motor drive voltage exceeded limit set by
firmware.
2 Carriage motor overcurrent detected by hardware.
3 Carriage motor force exceeded limit set by firmware.
4 Picker motor drive voltage exceeded limit set by
firmware.
5 Picker motor overcurrent detected by hardware.
6 Picker motor force exceeded limit set by firmware.
7 Low power supply during motion.
8 High power supply during motion.
9 Move stopped because cartridge-in-path beam blocked.
A Cartridge not detected by cartridge-in-path beam.
B Carriage motor not tracking properly.
C Picker motor not tracking properly.
D Carriage motor measured voltage less than expected.
E Picker motor measured voltage less than expected.
10 Find origin failed.
11 Calibrate failed.
Table B-10 Micro-Move Error Codes
Error Code
(hex.)
Failure Description