HP StoreOnce VSA Deployment and Configuration Guide (TC458-96024)

13. The StoreOnce VSA powers up and the storage and Instant On license are configured
automatically.
A DHCP network configuration is applied by default. For information about configuring static
IP addresses see To amend the network configuration after deployment (page 46).
NOTE: If there is a heavy load on the Hyper-V server, the StoreOnce services on the VSA
may take a long time to come up and the Instant On license application fails. If this happens,
use the StoreOnce CLI commands as follows:
• Use the license show command to check if an Instant On license is installed.
• If not, use the license add demo command to add the Instant On license.
This will enable StoreOnce Replication and Catalyst on the VSA for a period of 60 days.
NOTE: If the system is not able to assign a valid DHCP address, the service set will be in a
failed to start state. This must be resolved or a static IP address configured. Reboot the
StoreOnce VSA to bring the service set online.
28 Deployment on Microsoft Hyper-V