HP StoreEver MSL6480 Tape Library User and Service Guide

2. In the Access Group Name screen, enter the Group Name, and then click Next.
The library discovers and displays the attached host WWPNs. The SAN switch RMI that is
being used can also be referenced to see the WWPN-to-port association to help determine
which servers are attached.
3. In the Access Group Hosts screen, select the hosts for the group and then click Finish.
If no hosts are listed, check the following:
• Are all available hosts already assigned to other access groups? Each host can only be
assigned to one group. If necessary, click Back twice and then remove the host from
another access group.
• Is the host configured in the same zone controlled by the FC switch? Secure Manager
creates access groups as a refinement of zones configured by the FC switch. If you are
using FC switch zoning, the host and library must already be in the same zone.
• Is the host not physically connected to into the SAN? If not, connect the host to the SAN
or create a new host in the wizard to be connected into the SAN later. See “Configuring
hosts” (page 70).
To change the name of an access group:
1. Select the group from the list of Existing Groups, click Change Access Group Name, and then
click Next.
2. Enter the new group name and then click Finish.
To delete an access group:
• Select the group from the list of Existing Groups, click Delete Host Access Group, and then
click Finish.
To add a host to an access group:
1. Select the group from the list of Existing Groups, click Add Host to Group, and then click Next.
2. Select one or more available hosts to add to the group and then click Finish.
If no hosts are listed, check the following:
• Are all available hosts already assigned to other access groups? Each host can only be
assigned to one group. If necessary, click Back twice and then remove the host from
another access group.
• Is the host configured in the same zone controlled by the FC switch? Secure Manager
creates access groups as a refinement of zones configured by the FC switch. If you are
using FC switch zoning, the host and library must already be in the same zone.
• Is the host not physically connected to into the SAN? If not, connect the host to the SAN
or create a new host in the wizard to be connected into the SAN later. See “Configuring
hosts” (page 70).
To remove a host from an access group:
1. Select the group from the list of Existing Groups, click Remove Host from Group, and then
click Next.
2. Select one or more hosts to remove from the group and then click Finish.
Configuring device access
To configure device access, click Edit next to Device Access Configuration.
1. Select one of the groups and then click Next.
2. Expand the partition entries and check the ports that you would like accessible with this group.
3. After configuring each partition, click Finish.
Configuring the library 69