HP StoreEver MSL6480 Tape Library User and Service Guide

• Operation — (Administrator user only) Click or tap to access operation functions. See
“Operating the library” (page 79).
• Status — Click or tap to access status information. See “Viewing status information” (page 83).
• Service Area — (Service user only) Click or tap to access to functionality restricted to service
engineers. Both the service and administrator passwords are required to log in as the service
user.
Configuring the library
Using the Initial Configuration Wizard
The wizard guides you through setting the administrator password, configuring the timezone, date
and time, and library network settings, and then starting an initial system test. You can skip items
and stop the wizard at any time.
Once you have configured the network settings and set the administrator password from the OCP,
you can initiate the wizard from the RMI or OCP to complete the remaining configurations.
Saving, restoring, and resetting the library configuration
From the Configuration > System > Save/Restore Configuration screen you can save the library
configuration settings to a file, restore the settings, or reset the library configuration to the default
settings. The saved configuration database will make it easier it recover the library configuration
if you need to replace the base module or base module controller.
NOTE: The library only supports FAT-32 formatted USB flash devices. FAT-32 is the most common
flash drive format.
Figure 4 Configuration > System > Save/Restore Configuration screen
Saving the library configuration to a file
1. Navigate to the Configuration > System > Save/Restore Configuration screen.
2. If you will be saving the configuration file to a USB device on the library, insert a USB flash
drive into one of the USB ports on the base module.
Configuring the library 43