HP StoreEver MSL6480 Tape Library User and Service Guide

TIP: Check the online help in the RMI for additional information. The help pages are updated
with firmware updates and often contain up-to-date technical details that might not be contained
in this document. To access RMI help, click the ? icon on the right side of the RMI top banner.
Logging in to the library
Figure 3 Login screen
To log in to the library:
1. OCP: If the OCP screen saver is on, tap the screen.
RMI: Open a supported web browser and enter the IP address of the library in the browser’s
address bar
2. Select the User.
3. If required, enter the Password.
4. Click Login.
The users are:
• User — No password is required (leave the Password blank unless the user password has
been set).
The user account provides access to status information, but not configuration, maintenance or
operation functions.
• Administrator — The administrator password is required to login as the administrator user.
The same administrator password is used for the RMI and OCP. There is not a default
administrator password; the administrator password must be set with the OCP before
administrator functions can be used with the RMI. If the administrator password is lost, contact
support to generate a temporary password that will grant administrator access for a limited
period of time.
The administrator user has access to all functionality except for the security and service features.
• Security — The security password is required to login as the security user. The default security
password is security. If the security password is lost, the service password is required to
change the security password.
The security user has access to all administrator functionality and can also configure security
features and change the security user password.
• Service — Access to this user is by service personnel only. The service password is set at the
factory. The same service password is used for the RMI and OCP. Both the administrator and
service passwords are required for a service person to enter the service area.
TIP: By default, the administrator password is unset; all of the digits are null. You must set the
administrator password from the OCP to protect the administrator functions on the OCP and access
the administrator functions on the RMI.
40 Operating the library