HP StoreEver MSL6480 Tape Library User and Service Guide

<4mm
4. Use your fingers or a #2 Phillips screwdriver to tighten the captive fasteners on each side of
the module until they are finger tight. Do not over tighten.
5. Repeat steps 2 through 4 to install the rest of the modules into the rack.
6. Once all modules are installed, you can remove the protective film from the front of the base
module.
Aligning and connecting modules
Skip this step if the library does not have expansion modules.
Aligning the modules ensures that the robot can move freely between the modules. The library will
not operate unless the alignment mechanism is in the locked position.
CAUTION: Do not use the alignment mechanism to force the modules into alignment.
The alignment mechanism is designed to hold the modules in position once they are aligned, but
is not intended to adjust the module positions.
1. From the front of the library, loosen the thumbscrews on each of the modules two full turns.
Aligning and connecting modules 31