HP StoreEver MSL6480 Tape Library User and Service Guide

4. On the front of both rails in a square-hole rack, install a clip nut above the mounting bracket
as shown
For increased stability, install the retention inserts from the packet labeled Retention inserts
using a T10 Torx driver.
1
2
3
4
The library has a three-part rail system:
• Outer rail is installed in the rack.
• Middle rail connects to the inner and outer rails so the module can be slid out of the rack.
• Inner rail is attached to the module.
To install the modules in the rack, starting with the bottom module:
1. Extend the middle rails until they lock into place. Move the sliding assembly to the front of the
middle rails.
1
2
Installing the modules in the rack 29