HP StoreEver MSL6480 Tape Library User and Service Guide

To move a library cover plate from the base module to an extension module:
1. Remove the library cover plate from the base module.
a. Place the base module on a work table.
If you are removing the bottom cover, gently turn the base module over so you can access
the bottom of the module.
b. Insert a small flathead screwdriver or Torx screwdriver into the hole to retract the spring
lock, slide the cover until it reaches the tool, remove the tool and continue sliding the
cover to the front of the module until all the tabs are released.
1
2
2
c. Remove the cover from the module.
d. If the base module is upside down, gently return it to its normal position.
Preparing the top and bottom modules 25