HP StoreEver MSL6480 Tape Library User and Service Guide

Table 22 Warning events (continued)
Details and solutionMessage and descriptionEvent code
A drive that does not support encryption is
configured as part of a partition with encryption
A drive that does not support encryption is
configured in a partition with encryption enabled.
4059
enabled. The library has taken the drive offline.
Replace the drive with an LTO-4 or later generation
drive or disable encryption for the partition.
Connection to the KMIP server failed.4060 1. Verify the username and password configured
to log into the KMIP server.
2. Verify that all necessary SSL certificates have
been configured.
3. Verify that the KMIP server is reachable within
the network.
4. Verify that the configured IP addresses and/or
hostnames are correct.
Verify that the requested key is available on the
KMIP server. Check the KMIP server logs for
additional details.
Key not found on KMIP server.4061
Check the KMIP server logs for additional details
about why key creation failed.
Key creation on KMIP server failed.4062
Use the KMIP configuration wizard to verify the
KMIP configuration.
KMIP configuration invalid.4063
Disable the KMIP feature or install the necessary
license.
KMIP feature is not licensed.4064
Check event details for additional information.A tape alert flag was reported by a drive.4065
Check cabling and all network components between
the affected drive and host computer.
Automatic control path failover by disabling LUN
drive failed; partition may be disconnected from
host.
4066
Replace the cleaning cartridge.Cleaning cartridge will soon be expired and should
be replaced.
4067
Autocleaning is enabled but the library does not
contain a labeled cleaning cartridge so it was
No cleaning cartridge found.4068
unable to perform the autocleaning function for one
or more drives. Install a valid and properly labeled
cleaning cartridge and then perform a load and
unload on any drives that need cleaning to initiate
autocleaning.
Ensure that the drive is powered on, is
communicating with the library, and has current
Configuring the drive default map ID was not
possible.
4069
firmware. If this error persists, disable Secure
Manager for the library and re-enable it. Secure
Manager is only supported on LTO-4 and later
generation FC drives.
Verify that the requested key is either available on
the ESKM server or that the encryption kit token
Key not found on ESKM server and key not
available on PLK token.
4070
containing the requested key is inserted and logged
in.
Verify that the power supply fan is spinning and
ensure that there are no obstructions in the fan.
Power supply fan failed.4071
Autocleaning is enabled but the library does not
contain a labeled cleaning cartridge so it was
No cleaning cartridge in partition available for auto
cleaning.
4072
unable to perform the autocleaning function for one
or more drives. Install a valid and properly labeled
cleaning cartridge and then perform a load and
164 Event codes