HP StoreEver MSL6480 Tape Library User and Service Guide

Table 22 Warning events (continued)
Details and solutionMessage and descriptionEvent code
Verify that all tape cartridges have a high-quality
proper barcode label, as specified in “Labeling
tape cartridges” (page 15).
One of the library tests failed because of a source
element or destination element is not accessible.
4044
Drive is offline because no ESKM key generation
policy available.
4045 1. Check the network connection and ESKM server
configuration for the specified partition.
2. After ensuring that all partitions have the same
KeyGenPolicy, rerun the Expert Partitioning
wizard for the specified partition.
3. From the Status > Security screen verify that all
drives and partitions are configured correctly for
encryption. Test connectivity using the
Connectivity Check button.
Example ESKM server KeyGenPolicy for a
three-partition library:
SER1020633_LL01 KT
SER1020633_LL02 KT
SER1020633_LL03 KT
Disable path failover or install the necessary failover
license.
The drive configuration failed because of missing
DPF license.
4046
The drive configuration failed because of missing
CPF license.
4047
Disable basic path failover for this drive or replace
the drive with one supporting this feature.
The drive configuration failed because of
unsupported BDPF feature selected.
4048
The drive configuration failed because of
unsupported BCPF feature selected.
4049
Check cabling and all network components between
the affected drive and host computer.
Basic data path failover occurred.4050
A new encryption key could not be created because
media is loaded in one or more drives. Unload the
4051
media from all drives and then retry the manual key
creation again.
A new encryption key could not be created because
media is loaded in one or more drives. Unload the
4052
media from all drives and then automatic key
generation will occur during the next scheduled
time frame, or generate a new token key manually.
Check cabling and all network components between
the affected drive and host computer.
Manual control path failover from active to passive
drive failed; partition may be disconnected from
host.
4053
Check surrounding events for details and then retry
the operation.
Encryption configuration failed4055
The partition no longer has a passive drive that is
available for control path failover. Reconfigure the
Failed to copy settings from active to passive drive
in basic control path failover.
4056
partition so that at least one drive in the partition is
available for control path failover.
Verify that the configured control path failover drive
is present, powered on, and ready to accept the
control path.
Passive control path drive not available for control
path failover.
4057
If the failover is unplanned or unexpected, verify
that the host still sees both the active and passive
Disabling active control path drive caused failover
to passive one. This event applies to Basic CPF.
4058
drives. If necessary, reconfigure a different passive
drive for the partition.
163