HP StoreEver MSL6480 Tape Library User and Service Guide

Table 22 Warning events (continued)
Details and solutionMessage and descriptionEvent code
Verify that the LTO generation on the media bar
code label matches the LTO generation of the tape
Incompatible media move operation blocked by
media barcode ID check.
4029
cartridge. Replace the label if it is incorrect or
remove the incompatible cartridge from the library.
Remove the cartridge and inspect it for damage. If
the operation fails again, retry the operation with
another cartridge.
Move cartridge operation failed due to media error.4030
Move operation to tape drive failed because of a
media error when loading.
4031
Connection to the ESKM failed.4032 1. Verify that the configured IP addresses and/or
hostnames are correct.
2. Verify the username and password configured
to log into the ESKM server.
3. Verify that all necessary SSL certificates have
been configured.
4. Verify that the ESKM server is reachable within
the network.
Unsupported keygen policy.4033 1. Check the network connection and ESKM server
configuration for the specified partition.
2. After ensuring that all partitions have the same
KeyGenPolicy, rerun the Expert Partitioning
wizard for the specified partition.
3. From the Status > Security screen verify that all
drives and partitions are configured correctly for
encryption.
Verify that the requested key is available on the
ESKM server. Check the ESKM server logs for
additional details.
Key not found on ESKM server.4034
Check the ESKM server logs for additional details
about why key creation failed.
Key creation on ESKM server failed.4035
Use the ESKM configuration wizard to verify the
ESKM configuration.
ESKM configuration invalid.4036
Verify that both FC ports are correctly cabled to the
SAN.
Loss of redundant data path.4037
Advanced path failover, ADPF and ACPF, are only
supported on LTO-6 and later generation tape
The drive configuration failed because of
unsupported ADPF features selected.
4038
drives. Disable advanced path failover for this drive
or replace it with a drive supporting this feature.
The drive configuration failed because of
unsupported ACPF features selected.
4039
Check the cabling and all network components
between the affected drive and host computer.
Data path failover occurred.4040
Ensure that both power supplies for each module
are installed properly and that each power supply
is connected to a valid power source.
Wellness test failed because of power supply
redundancy test failed.
4041
Disable ESKM or install the necessary ESKM license.ESKM feature not licensed.4042
If the failover was unplanned or unexpected, verify
that the host still sees both the active and passive
Control path failover occurred. This event applies
to Advanced CPF.
4043
drives. If necessary, reconfigure a different passive
drive for the partition.
Check the cabling and all network components
between the affected drive and host computer.
162 Event codes