HP StoreEver MSL6480 Tape Library User and Service Guide

1
2
3
4
5
6. If removing a base module bezel, disconnect the OCP cable.
Installing the bezel
1. If installing a base module bezel, connect the OCP cable to the new OCP.
Ensure that the OCP cable is correctly routed in the channel behind the clear plastic window.
2. Place the bottom tabs of the bezel into the slots in the bottom of the module.
3. Rotate the bezel and snap in the top corners.
1
2
Powering on the library
Power on the library by pressing the power button on the base module just below the OCP; the
green light will illuminate. When the library is powered on, it inventories the tape cartridges in the
magazines, checks the firmware version on all modules, configures the tape drives, confirms the
presence of the existing modules, and searches for any new modules.
132 Upgrading and servicing the library