HP StoreEver MSL6480 Tape Library User and Service Guide

9. While pressing the latch near the top of the spooling mechanism, pull the entire spooling
mechanism gently up until you see it clear the narrow part of the keyhole in the back left of
the metal wall. It may help to push up from the bottom with your other hand.
10. Pull the spooling mechanism toward the front of the module until it disconnects and remove it
from the module.
1
2
Installing the robotic assembly and spooling mechanism into the base module
1. Hold the spooling mechanism so that the end of the spooling cable that attaches to the robotic
assembly is pointing up.
2. Align the tab on the back of the spooling mechanism with the keyhole in the back left of the
metal wall.
3. Push the spooling mechanism in and down until it snaps into place.
4. The robotic assembly is shipped with the robot in the unlocked position. Verify that it is
unlocked. If the robot is locked, unlock it; standing at the front of the module, move the blue
lever to the left, then toward you, then to the right.
128 Upgrading and servicing the library