HP StoreEver MSL6480 Tape Library User and Service Guide

1
2
2
4. Lift the robotic assembly gently from the module and place it on top of the module on the right
side (opposite the spooling mechanism) and slightly to the front. Take care not to damage the
spooling cable.
5. On the top of the robotic assembly where the spooling cable is attached, use a small flat head
or Torx screwdriver driver to press and push the small latch that unlocks the spooling cable.
Note where the end of the spooling cable pivots in the robotic assembly. This is important to
know when you attach the new spooling cable to the robotic assembly.
6. Lift the spooling cable from the robotic assembly and place it in its cradle at the top of the
spooling mechanism.
1
2
3
7. Set aside the robotic assembly.
IMPORTANT: If there is a tape cartridge still in the cartridge carrier, remove the cartridge
by lifting it straight up; you may need to move the cartridge slightly from side to side.
8. Extend the left magazine out of the rack by approximately 15 cm (6 inch).
Replacing the robotic assembly and spooling mechanism 127