HP StoreEver MSL6480 Tape Library User and Service Guide

“Preparing the top and bottom modules” (page 24) for details; while this procedure refers to moving
a cover from the base module, the information is the same for moving a cover from an expansion
module.
The replacement module is shipped with a bottom cover plate but not a top cover plate. Move the
cover plates as necessary so the replacement module has the cover plates in the same location as
the empty module and the empty module has a bottom cover plate.
Installing the module into the rack
1. Extend the middle rails until they lock into place. Move the sliding assembly to the front of the
middle rails.
1
2
2. Slide the inner rails, which are attached to the module, into the middle rails. Slide the module
into the rack.
1
2
3. Use your fingers or a #2 Phillips screwdriver to tighten the captive fasteners on each side of
the module until they are finger tight. Do not over tighten.
122 Upgrading and servicing the library