HP StoreEver MSL6480 Tape Library User and Service Guide

3. Use one hand to completely remove the magazine from the module while using the other hand
to support the bottom.
Installing the magazine
1. Position the upper and lower magazine rails onto the alignment rails.
2. Push in slowly until the magazine rails are properly seated and the magazine is only slightly
extended (stop before locking the magazine).
3. Pull the magazine back out until fully extended.
4. Load the tape cartridges into the new magazine in the same locations they were in previously.
5. Push the magazine handle slowly until the magazine release latch snaps into place. The
magazine locks into place after it is correctly installed.
Replacing a magazine 117