HP StoreEver MSL6480 Tape Library User and Service Guide

3. Slowly pull the magazine handle until the magazine is free of the latch.
Removing the tape cartridges
1. Slowly pull the magazine handle until the magazine is fully extended.
2. Remove the tape cartridges noting their locations within the magazine. You will place them
in the same locations in the new magazine after it is installed.
Removing the magazine
1. Push the magazine approximately 12 mm (0.5 inches) back into the module to remove tension
from the release mechanism.
2. On the back side of the magazine, while pushing the two red latches toward the front of the
rack slide the magazine until clear of the release mechanism.
116 Upgrading and servicing the library