HP StoreEver MSL6480 Tape Library User and Service Guide

Moving a cover to the new module
The library has removable top and bottom covers. When adding a module, you must move either
the top or the bottom cover to the new module. The two covers are identical and the process for
removing and installing them is the same for the top and bottom of the module. See “Preparing
the top and bottom modules” (page 24) for details; while this procedure refers to moving a cover
from the base module, the information is the same for moving a cover from an expansion module.
Installing the module in the rack
1. Extend the middle rails until they lock into place. Move the sliding assembly to the front of the
middle rails.
1
2
2. Slide the inner rails, which are attached to the module, into the middle rails. Slide the module
into the rack.
1
2
Adding an expansion module 101