HP StoreEver MSL6480 Tape Library Rack Kit Replacement (QU625-96301, June 2013)

3
1
2
3. On the front of both rails in a square-hole rock,
ensure that the clip nut is mounted as shown, and
for increased stability, install the retention inserts
from the packet labeled Retention inserts.
1
2
3
4
Installing the module into the rack
1. Extend the middle rails until they lock into place.
Move the sliding assembly to the front of the
middle rails.
1
2
2. Slide the inner rails, which are attached to the
module, into the middle rails. Slide the module
into the rack.
1
2
3. If you are installing multiple modules, verify that
this module has been installed directly above or
below its adjacent module and is contained within
the correct 6U volume. The gap between modules
must be less than 4 mm.
4. Use your fingers to tighten the captive thumbscrew
on each side of the module.
Page 5