HP StoreEver MSL6480 Tape Library Rack Kit Replacement (QU625-96301, June 2013)

interface (RMI). If these methods fail, or if a magazine
needs to be removed when the power to the device is
off, you can release the magazine manually.
Using the OCP
1. Log in as an administrator.
2. On the home screen, tap Open Magazine.
3. Tap Unlock in the left or right magazine column
within the module containing the magazine to be
.
4. Tap Submit. A message box indicates when the
magazine has been unlocked.
5. Tap OK to close the message. The Open
Magazine screen shows that the magazine is now
unlocked.
NOTE: If not removed, the magazines and the
mailslot will relock after 30 seconds.
Using the manual release
1. Open the magazine access door.
2. Insert a small flat head screwdriver or Torx driver
into the appropriate magazine release hole.
IMPORTANT: Do not exert force once you
encounter resistance. Doing so can damage
the device.
3. Slowly pull the magazine handle until the
magazine is free of the latch.
Removing the tape cartridges
1. Slowly pull the magazine handle until the
magazine is fully extended.
2. Remove the tape cartridges noting their locations
within the magazine. You will place them in the
same locations in the replacement module.
Powering off the library
• Press the power button just below the OCP and
hold for three seconds; the green light will go off.
NOTE: Under normal circumstances, when the
library is powered off using the front power
button the robot automatically parks and locks
into the base module behind the OCP.
Page 2