HP StoreEver MSL6480 Tape Library Power Supply Replacement (QU625-96009, June 2013)

HP StoreEver MSL6480 Tape

Library Power Supply

Replacement

Abstract

The power supply is a mandatory customer self repair part.

HP customer self repair (CSR) programs allow you to repair

your StoreEver product. If a CSR part needs replacing, HP

ships the part directly to you so that you can install it at your

convenience. For more information about CSR, contact your

local service provider. For North America, see the CSR

website: www.hp.com/go/selfrepair

*QU625-96009*

HP Part Number: QU625-96009

Published: June 2013

Edition: 1

CAUTION: Parts can be damaged by

electrostatic discharge. Keep parts in

electrostatic containers until needed. Ensure you

are properly grounded when touching static

sensitive components.

Identifying the failed component

Using the OCP (operator control panel) or RMI (remote

management interface):

1. Activate the UID (Unit Identification) LEDs from

the Maintenance→UID LED Control screen. This

will illuminate the blue LED on the front and rear

of the base module to identify the library

containing the failed component.

2. Identify the module within the library that contains

the failed component:

a. In the upper left corner of the Home screen,

locate the module that indicates an error.

b. Click or tap the module for information on

the failed component.

Preparing to remove the power supply

1. Locate the failed power supply on the rear of the

library by the LEDs; either the amber LED (2) will

be lit or all three LEDs will be unlit.

2. Unplug the AC power cord from the power supply

you are replacing.

Page 1

PAGE 1
HP StoreEver MSL6480 Tape Library Power Supply Replacement CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in electrostatic containers until needed. Ensure you are properly grounded when touching static sensitive components. Abstract The power supply is a mandatory customer self repair part. HP customer self repair (CSR) programs allow you to repair your StoreEver product. If a CSR part needs replacing, HP ships the part directly to you so that you can install it at your convenience.
PAGE 2
Removing the power supply NOTE: Proper cooling of the library requires that both power supplies be installed. Before removing the failed power supply, have the new power supply unpackaged and ready for immediate replacement. 1 2 Power supplies within a module are redundant; one power supply may be removed and replaced without interrupting the library. 1. 2. 3. Loosen the three blue captive thumbscrews on the power supply.
PAGE 3
Regulatory information For important safety, environmental, and regulatory information, see Safety and Compliance Information for Server, Storage, Power, Networking, and Rack Products, available at http://www.hp.com/support/ Safety-Compliance-EnterpriseProducts. Documentation feedback Send any errors, suggestions, or comments to Documentation Feedback (docsfeedback@hp.com).