HP StoreEver MSL6480 Tape Library OCP, Bezel, and Magazine Access Doors Replacement (QU625-96302, June 2013)

1
2
3
4
5
6. If removing a base module bezel, disconnect the
OCP cable.
Installing the bezel
1. If installing a base module bezel, connect the
OCP cable to the new OCP.
Ensure that the OCP cable is correctly routed in
the channel behind the clear plastic window.
2. Place the bottom tabs of the bezel into the slots
in the bottom of the module.
3. Rotate the bezel and snap in the top corners.
1
2
Removing the magazine access doors
1. Insert a small flat head screwdriver into the slot
directly above the top hinge.
2. Use the screwdriver to pry the hinge free of the
module while pulling the door toward you.
3. Remove the door from the module.
1
2
3
4
Installing the magazine access doors
NOTE: The doors are identical and can be
mounted on either side of the module.
1. Orient the door so that the hinges are to the
outside of the module.
2. With the door almost closed, insert the bottom
hinge into the small recess on the module.
3. Snap the top hinge into place.
4. Verify that the door opens and closes normally.
1
2
Powering on the library
If the library was powered off, power on the library
by pressing the power button on the base module just
below the OCP; the green light will illuminate.
Verify that the library initializes and becomes ready,
and that the OCP is operating normally.
Getting help
• HP Product information: http://www.hp.com/go/
msl
• HP technical support and phone numbers:
www.hp.com/support
• HP Library & Tape Tools (L&TT) diagnostic
software: www.hp.com/support/tapetools
Page 2