HP StoreEver MSL6480 Tape Library OCP, Bezel, and Magazine Access Doors Replacement (QU625-96302, June 2013)

ManualsBrandsHP ManualsStorageHP StoreEver MSL6480 Scalable Base Module

HP StoreEver MSL6480 Tape

Library OCP, Bezel, and

Magazine Access Doors

Replacement

Abstract

The bezel and doors are mandatory customer self repair

parts. HP customer self repair (CSR) programs allow you to

repair your StoreEver product. If a CSR part needs

replacing, HP ships the part directly to you so that you can

install it at your convenience. For more information about

CSR, contact your local service provider. For North America,

see the CSR website: www.hp.com/go/selfrepair

*QU625-96302*

HP Part Number: QU625-96302

Published: June 2013

Edition:

CAUTION: Parts can be damaged by

electrostatic discharge. Keep parts in

electrostatic containers until needed. Ensure you

are properly grounded when touching static

sensitive components.

NOTE: The OCP (operator control panel) is

only attached to a base module bezel; the OCP

is not included on an expansion module bezel.

This replacement kit may contain components

that you do not need; only replace those

components that are necessary. This document

may describe components not included in your

kit.

Powering off the library

NOTE: Power off the library if you are

replacing a bezel. If you are only replacing

doors, skip this step.

1. Verify that any applications using the library are

idle.

2. Press the power button just below the OCP and

hold for three seconds; the green light will go off.

NOTE: Under normal circumstances, when the

library is powered off using the front power

button the robot automatically parks and locks

into the base module behind the OCP.

Removing the bezel

1. Open the magazine access doors.

2. On one side of the bezel near the top, insert a

small flat head or Torx screwdriver into the bezel

release hole.

3. Push the screwdriver gently toward the middle of

the bezel until that corner of the bezel is released.

4. Release the other top corner in the same manner.

5. Pull the bezel up until clear of the bottom brackets.

NOTE: If removing a base module bezel,

pull gently to avoid damaging the OCP

cable. Note where the OCP cable is

located, routed, and attached.

Page 1

Summary of content (2 pages)

PAGE 1
HP StoreEver MSL6480 Tape Library OCP, Bezel, and Magazine Access Doors Replacement CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in electrostatic containers until needed. Ensure you are properly grounded when touching static sensitive components. NOTE: The OCP (operator control panel) is only attached to a base module bezel; the OCP is not included on an expansion module bezel. Abstract The bezel and doors are mandatory customer self repair parts.
PAGE 2
1 2 4 3 1 3 4 5 6. If removing a base module bezel, disconnect the OCP cable. Installing the magazine access doors NOTE: The doors are identical and can be mounted on either side of the module. Installing the bezel 1. 2. 3. If installing a base module bezel, connect the OCP cable to the new OCP. 1. Ensure that the OCP cable is correctly routed in the channel behind the clear plastic window. Place the bottom tabs of the bezel into the slots in the bottom of the module.