HP StoreEver MSL6480 Tape Library Magazine Replacement (QU625-96008, June 2013)

Using the RMI
1. Log in as an administrator.
2. On the home screen, click Open Magazine.
3. Click Unlock in the left or right magazine column
within the module containing the magazine to be
replaced.
4. Click Submit. A message box indicates the
magazine has been unlocked.
5. Click OK to close the message. The Open
Magazine screen shows that the magazine is now
unlocked.
NOTE: The magazines and the mailslot will
relock again after 30 seconds.
Using the manual release
1. Open the magazine door cover.
2. Insert a small flathead screwdriver or Torx driver
into the appropriate magazine release hole.
IMPORTANT: Do not exert force once you
encounter resistance. Doing so can damage
the device.
3. Slowly pull the magazine handle until the
magazine is free of the latch.
Removing the tape cartridges
1. Slowly pull the magazine handle until the
magazine is fully extended.
2. Remove the tape cartridges noting their locations
within the magazine. You will place them in the
same locations in the new magazine after it is
installed.
Removing the magazine
1. Push the magazine approximately 12 mm (0.5
inches) back into the module to remove tension
from the release mechanism.
2. On the back side of the magazine, while pushing
the two red latches toward the front of the rack
slide the magazine until clear of the release
mechanism.
Page 2