HP StoreEver MSL6480 Tape Library Magazine Replacement (QU625-96008, June 2013)

HP StoreEver MSL6480 Tape

Library Magazine

Replacement

Abstract

The magazine is a mandatory customer self repair part. HP

customer self repair (CSR) programs allow you to repair

your StoreEver product. If a CSR part needs replacing, HP

ships the part directly to you so that you can install it at your

convenience. For more information about CSR, contact your

local service provider. For North America, see the CSR

website: www.hp.com/go/selfrepair

*QU625-96008*

HP Part Number: QU625-96008

Published: June 2013

Edition: 1

Unlocking the magazine

HP recommends unlocking the magazine using the

operator control panel (OCP) or remote management

interface (RMI). If these methods fail, or if a magazine

needs to be removed when the power to the device is

off, you can release the magazine manually.

NOTE: As a best practice, perform this

procedure while applications are idle. While

the magazine is removed, the library robot

cannot move media within that magazine.

Using the OCP

1. Log in as an administrator.

2. On the home screen, tap Open Magazine.

3. Tap Unlock in the left or right magazine column

within the module containing the magazine to be

replaced.

4. Tap Submit. A message box indicates when the

magazine has been unlocked.

5. Tap OK to close the message. The Open

Magazine screen shows that the magazine is now

unlocked.

NOTE: The magazines and the mailslot will

relock again after 30 seconds.

Page 1

PAGE 1
HP StoreEver MSL6480 Tape Library Magazine Replacement Unlocking the magazine HP recommends unlocking the magazine using the operator control panel (OCP) or remote management interface (RMI). If these methods fail, or if a magazine needs to be removed when the power to the device is off, you can release the magazine manually. Abstract The magazine is a mandatory customer self repair part. HP customer self repair (CSR) programs allow you to repair your StoreEver product.
PAGE 2
Using the RMI 1. 2. Log in as an administrator. On the home screen, click Open Magazine. 3. Click Unlock in the left or right magazine column within the module containing the magazine to be replaced. 3. Slowly pull the magazine handle until the magazine is free of the latch. Removing the tape cartridges 4. 5. Click Submit. A message box indicates the magazine has been unlocked. Click OK to close the message. The Open Magazine screen shows that the magazine is now unlocked. 1.
PAGE 3
. Use one hand to completely remove the magazine from the module while using the other hand to support the bottom. Verifying the magazine installation and operation Using the OCP or RMI: 1. Confirm that the replaced magazine is closed. 2. Confirm that the cartridges in the replaced magazine are inventoried. If you replaced the right magazine, confirm that the cartridges in the mailslot are inventoried. 3.