HP StoreEver MSL6480 Tape Library Drive Power (DC-DC Converter) Board Replacement (QU625-96305, June 2013)

Powering on the library
Power on the library by pressing the power button on
the base module just below the OCP; the green light
will illuminate. When the library is powered on, it
inventories the tape cartridges in the magazines,
checks the firmware version on all modules, confirms
that only compatible drives are installed, confirms the
presence of the existing modules, and searches for
any new modules.
Verifying the drive power board installation
1. Verify that all drives that are present are powered
on:
a. Check the OCP or RMI for events.
b. From the back of the library, verify that the
green LED on each drive is illuminated.
2. Verify that the new drive power board is
operating properly by checking the OCP or RMI;
the event that indicated the drive power board
was faulty should be cleared.
3. If the UID LEDs are still illuminated, deactivate
them using the OCP or RMI.
4. Resume the host applications.
Getting help
• HP Product information: www.hp.com/products/
tapestorage
• HP technical support and phone numbers:
www.hp.com/support
• HP Library & Tape Tools (L&TT) diagnostic
software: www.hp.com/support/tapetools
Regulatory information
For important safety, environmental, and regulatory
information, see Safety and Compliance Information
for Server, Storage, Power, Networking, and Rack
Products, available at http://www.hp.com/support/
Safety-Compliance-EnterpriseProducts.
Documentation feedback
Send any errors, suggestions, or comments to
Documentation Feedback ([e-mail]).
Page 3