HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Power Supply (+48v 1500w) Installation and Replacement Instructions (QP008-96004, May 2013)

ManualsBrandsHP ManualsStorageHP StoreEver ESL G3 100 slot Tape Library

HP StoreEver Enterprise

Systems Library (ESL) G3 Tape

Library

Power Supply (+48V 1500W)

Installation and Replacement

Instructions

Abstract

This document describes how to remove and replace an

existing or install a new +48V 1500W power supply in an

ESL G3 Tape Library.

Printed in the US

*QP008-96004*

HP Part Number: QP008-96004

Published: May 2013

Edition: 3rd

CAUTION: Parts can be damaged by

electrostatic discharge. Keep parts in their

containers until needed. Make sure that you are

properly grounded when touching static sensitive

components.

NOTE: If the power supply is redundant (there

is another one in the module), the power supply

is hot-swappable; you do not have to turn off

power to the library or module to remove and

replace a redundant power supply.

Inspect the contents of the kit

The kit contains one +48V 1500W power supply.

You will also need the ESD strap that shipped with the

ESL G3.

Prepare the library

1. If you are replacing the only power supply in the

module, power off the library:

a. Make sure there is no I/O activity on any of

the partitions.

b. Make sure that you are viewing the physical

library. From the View menu or in the

Managed Views region of the Operator

Control Panel (OCP), click the name of the

physical library.

c. Select Operations→System Shutdown.

The System Shutdown dialog box appears

with Shutdown selected as the default.

d. Select Shutdown, then click OK in the

confirmation dialog box.

When the shutdown process completes, the

OCP display turns dark.

e. To turn off power to the library, press the

Power button on the indicator panel.

2. Open the service door to the module.

3. Attach the ESD strap to your wrist and to an

unpainted surface inside the door.

Page 1

Summary of content (3 pages)

PAGE 1
HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in their containers until needed. Make sure that you are properly grounded when touching static sensitive components.
PAGE 2
4. On the power distribution unit (PDU) to the right of the power supply that is being replaced, set the power switch to the down position to turn power off. Remove the power supply blank plate (new installation only) 1. Loosen the thumbscrews that secure the blank plate to the module. 1. Blank plate thumbscrews 1. Power switch 2. 3. Remove the existing power supply (replacement only) Loosen the thumbscrew on the power supply and pull it toward you to remove it from the housing.
PAGE 3
2. 3. If the library was powered off for this procedure, press the Power button on the indicator panel to power it back on. The library begins to boot up. A library with only a few drives usually will be fully powered on and ready for use within 10 minutes. However, if a library is large with a high number of drives, it can take more than an hour for the library to fully power on, complete its discovery process, and become ready for use. During the power on process, the Robotics Enabled indicator flashes.