HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Parking, Control, Expansion, or High Density Expansion Module Unpacking Instructions (QN998-96101, May 2013)

3. Open the service door (at the back of the module).
4. Use a 14 mm socket wrench to remove the bolts
that hold the wood block and foam brace in place
at the floor of the module.
1. Two 14 mm bolts
2. Wood block and foam brace
5. Remove the wood block and foam brace from the
floor of the module.
6. Close the service door.
7. Position the ramp at the back of the unit.
8. Place the metal ramp grip feet in the holes on the
pallet, then seat the feet in the holes.
1. Holes in the pallet
2. Metal ramp grip feet
The ramp extends from the back of the module
and both tracks rest evenly on the floor.
9. Flip the metal ramp extensions at the floor end of
the ramp out so that they also rest evenly on the
floor.
1. Metal ramp extensions
10. Carefully roll the library off of the pallet and to
the installation site.
WARNING! This step must be completed
by two people. Do not attempt to perform
this step alone.
WARNING! Do not stand at the bottom
of the ramp and pull the library toward you.
11. Open the library door and remove the cardboard
spacers inserted between drives.
1. Cardboard spacers
Page 3