HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library HDEM Motor Replacement Instructions

1. Lockdown bolt
5. Turn the 5 mm tension bolt clockwise to release
the spring tension, and ease belt tension so the
motor can be removed.
CAUTION: Do not turn the tension bolt
too far. You only need to release the belt
tension on the motor pulley enough for the
belt to easily slip over the motor pulley.
1. Tension bolt
6. Remove the three (3) 5 mm hex motor assembly
attachment bolts that attach the tower motor
assembly to the mounting plate.
1. Attachment bolts
7. Pivot the motor out from under the belt and off the
mounting plate locating pins.
NOTE: If replacing the belt, slide it away
and under the tower pulley then off.
Replacing motor assembly and drive belt
Required tools: 5 mm hex wrench
1. Slide the drive belt under and then up and around
the tower pulley.
1. Tower pulley
NOTE: If you're replacing the drive belt,
use the new belt for Step 1.
2. Tilt the motor slightly forward and tuck the motor
pulley inside the belt.
Page 2