HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Control Module Installation Instructions

19. Eth port 5 of EEB in slot 7 (corresponds to drive 5)
20. Eth port 6 of EEB in slot 7 (corresponds to drive 6)
21. EEB in slot 8 (corresponds to upper drive bay)
10. If any drives are not connected to an EEB, for
each drive, connect one end of the Ethernet
Crossover cable to the Ethernet port.
1. Ethernet port on the drive
Connect the other end to the appropriate EEB port
as follows:
Drive # (bottom to
top)
Drive bayPortEEB
12Upper drive bayEth 6Bay 8
(upper)
11Eth 5
10Eth 4
9Eth 3
8Eth 2
7Eth 1
6Lower drive bayEth 6Bay 7
(lower)
5Eth 5
4Eth 4
3Eth 3
2Eth 2
1Eth 1
Prepare to install expansion modules, if
any
If there are no expansion modules to install, continue
this procedure at Level the module.
If there are expansion modules to install, do not
perform the procedures in the rest of this instruction
document. Instead, do one of the following:
• If you are adding expansion modules (EMs),
continue library installation using HP StoreEver
Enterprise Systems Library (ESL) G3 Tape Library
Expansion Module Installation Instructions that
shipped with the expansion module.
• If you are adding high density expansion modules
(HDEMs), continue library installation using HP
StoreEver Enterprise Systems Library (ESL) G3
Tape Library High Density Expansion Module
Installation Instructions that shipped with the
HDEM.
• The following parts ship separately for expansion
modules and HDEMs; and must be installed in
the field:
◦ Tape drives (expansion module only)
◦ Drive 7-12 Readiness Kits — EEB (expansion
module only)
◦ Redundant power supplies
◦ HDEM barcode scanner (HDEM only)
Level the module
1. Lower the leveling legs/feet. To do so:
a. Use the 24 mm open end wrench to loosen
the four locking nuts on the four corner legs.
CAUTION: If you do not loosen the
locking nuts, you may strip the leveling
leg threads during movement.
b. Lower the four corner feet by hand until they
touch the floor.
You may have to use the 6 mm hex wrench
or 16 mm open end wrench to turn the legs
if the threads do not turn freely.
NOTE: To ensure even weight
distribution on the feet, it is very
important that all feet be brought into
contact with the floor without lifting the
module. You can verify whether a foot
is in contact with the floor by
attempting to slide a piece of paper
underneath it.
Page 4