HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Calibration Target Replacement Instructions (QN998-96103, May 2013)

Install the new calibration target

CAUTION: Calibration targets must be

installed in column 3, sections 1 and 10 on the

inside back wall, and column 2, sections 1 and

10 on the inside of the door. The locations for

calibration targets are identified with an X in

the drawing below.

1. Slide the bottom of the calibration target onto the

bottom of the correct magazine.

2. Push in the top of the calibration target until it

snaps on.

3. Make sure the calibration target is seated all the

way around the magazine.

4. Close the access door.

Prepare the library for use

1. On the operator panel, press the Robotics Enabled

button to enable the picker assembly.

2. Run the Configure and Calibrate teach test. See

HP StoreEver Enterprise Systems Library (ESL) G3

Tape Library User Guide, Teaching the Library

(Configuration and Calibration) section.

HP web sites

For additional information, see these HP web sites:

• http://www.hp.com

• http://www.hp.com/go/storage

• http://www.hp.com/service_locator

• http://www.hp.com/support/manuals

Page 2