HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library Air Filters Installation and Replacement Instructions (QN998-96083, May 2013)

ManualsBrandsHP ManualsStorageHP StoreEver ESL G3 100 slot Tape Library

HP StoreEver Enterprise

Systems Library (ESL) G3 Tape

Library

Air Filters Replacement

Instructions

Abstract

This document describes how to remove and replace existing

air filters in an ESL G3 Tape Library. There are two air filters

in each module. The filters are located at the top and bottom

of the module access door.

Printed in the US

*QN998-96083*

HP Part Number: QN998-96083

Published: May 2013

Edition: 2nd

CAUTION: Parts can be damaged by

electrostatic discharge. Keep parts in their

containers until needed. Make sure that you are

properly grounded when touching static sensitive

components.

Inspect the contents of the kit

The kit contains one air filter.

You will also need a #1 Phillips screwdriver and the

ESD strap that shipped with the ESL G3 Tape Library.

Prepare the library

1. Take the library offline:

a. Make sure there is no I/O activity on any of

the partitions.

b. Make sure that you are viewing the physical

library. From the View menu or in the

Managed Views region of the Operator

Control Panel (OCP), click the name of the

physical library.

c. Click Operations→Change Mode.

Alternatively, in the Managed Views section

of the LMC, click the mode button next to the

name of the physical library. (The button

reads either Online or Offline.)

The Change Library Mode dialog box

appears with the current state of the physical

library shown.

d. Select the Offline button to take the physical

library to an offline state.

2. On the OCP, press Robotics Enabled to return the

picker assembly to the home position.

3. Open the access door of the module.

NOTE: Aisle power is disabled.

4. Attach the ESD strap to your wrist and to an

unpainted surface inside the door.

Page 1

Summary of content (3 pages)

PAGE 1
HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in their containers until needed. Make sure that you are properly grounded when touching static sensitive components. Air Filters Replacement Instructions Inspect the contents of the kit The kit contains one air filter. You will also need a #1 Phillips screwdriver and the ESD strap that shipped with the ESL G3 Tape Library.
PAGE 2
4. Remove the existing air filter 1. Remove the air filter by sliding it to the right and pulling it out of the module door. CAUTION: The library can be brought back online without the air filter in place, if necessary. If an IEM board is attached to the retaining bar, the retaining bar and IEM board must be reinstalled before any library operation. Do not operate the library for more than a day without the filter. Locate the retaining bar across the air filter to be removed.
PAGE 3
HP web sites For additional information, see these HP web sites: • http://www.hp.com • http://www.hp.com/go/storage • http://www.hp.com/service_locator • http://www.hp.